• Kastrup Serrano posted an update 7 months ago

    Installed by pros, a full house can be installed or "hung" in one day. Taping, spackling and sanding will require typically 4 to 5 more work days until it’s ready for painting. With some practice, any homeowner can install drywall and attain an acceptable end result.

    If you have a chance to watch someone either hanging the drywall or really do the taping and spackle push the button can be a great help in seeing where did they get it done. Drywall will come in several unique thicknesses where there a several unique types for special applications. One of the most commonly seen drywall is certainly one half inch thick and is also used in most aspects of any home. Walls and ceilings both use 1 / 2 inch material. Inside my state, five eighths inch thick drywall or half inch fire code drywall is essential in attached garages and over a property boiler or furnace in a basement. Garages and boiler room drywall requires just a single coat of tape and spackle referred to as a fire coat, to avoid a hearth from penetrating the drywall at the seams and screws.

    Bathrooms are often considered wet areas and for that reason special green or water repellent drywall is utilized in different wet area. If hardwood will probably be applied then this drywall is a special coarse rough surface cement drywall board. Drywall is available with lead linings for X-ray rooms, special insulation paper backing, printed decoration faces, as well as a many other special applications.

    Standard sheets of drywall are available in four foot widths but lengths change from eight feet to sixteen feet as common sizes. Longer special order lengths are available. Many box stores and lumber yards carry lengths approximately twelve feet with fourteen and sixteen foot sheets being ordered. Homeowners typically will choose eight foot lengths because of the easy handling the pad but with a twelve foot wall, that causes another vertical four foot joint that needs to be taped and spackled. A twelve foot sheet would reach corner to corner. Make it happen within an entire house and you are considering numerous feet of extra work taping and sanding. That converts into many extra hours of labor.

    Installing drywall is usually a two person job mainly because handling the sheets is quite cumbersome. When installing drywall on the ceiling even a two person crew is just not sufficient. With anyone holding each side of the sheet the next installing either their nails or screws to lock it towards the studs or rafters, keeping the sheet tight on the wall and inline using the other sheets can be a chore. I have seen experienced installers hang five eighths inch twelve foot sheets on their own however, this but it takes numerous years of practice. Renting a drywall lift that will raise and hold a sheet set up will allow you to work alone.

    It is a much preferred practice to utilize screws when installing drywall on ceilings. Screws can be found in various lengths to suit the stipulations but inch and five eights in size is the most common size used. Screws can be bought in galvanized and stainless finishes too.

    Check out about

    instructions on arched drywall ceiling check our resource.

CONTACT ME

I'm not available right now. But you can send me an email and I'll get back to you, asap.

Sending

©2019  FreedomsRoad.org / Steve Davis

Log in with your credentials

or    

Forgot your details?

Create Account